
Reader Terminal Combo Technical Manual
After each address change or after device’s first installation power off and back on the device (for the
new settings to take effect) and obtain operating parameters.
Operating parameters are obtained through the Metra NET Network. The server must be set up and
running for that purpose. To obtain operating parameters, press the PARAMETERS REQUEST
button.
NOTE
Network based functionality will be present only if the server is running and the Reader Terminal has
been properly configured.
Network address
After installation is complete, the device network address must be set by DIP switches.
NOTE
Each Metra device must have different address setting.
Switch #1 must be set to OFF (switch down).
Look up the code for desired address in the coding table. Set switches #2 through #8 to indicated
positions, where:
0 indicates the corresponding switch is in OFF position (switch down)
1 indicates the corresponding switch is in ON position (switch up)
Coding table:
Comentarios a estos manuales